From the Interior Health Authority

In most cases, when you press Enter you will see the first category of error. For errors in the category, key a second time and the display should show the specific error. If the Control Card has recorded several errors within a single category, you can use up and down to scroll through the errors. If errors occur in several categories, the use of key to exit the category level, and then use the arrow keys to scroll through the different categories of error. As before, key to queue solution software enter the category and see the specific errors.To clear an error, press and key enter while queue management system the specific error is displayed on the screen. 

Sole focus patients waiting real time 

This usually indicates the condition that originally generated the error still exists and although the error has been deleted, the condition is not corrected. Therefore Control Board tells us the same mistake over and over again.For example, if the card Control reports an error Cooling/ Too Hot Cooling/ too hot, this error can not be successfully cleaned until the temperature drops enough teams to reach the set point temperature and it is not too hot. Some errors are transient, and always only displayed as the error condition persists. An example of this is the fault of Coin Communications Communication with the purse. This error is reported whenever the purse if connected queue management system to food has no communication. If communication is restored, the error is automatically cleared.



 

If communication is queue solution software interrupted when entering the service mode, this error is reported. Service Mode Insert or Dispense currency, it queue management system allows the user to insert coins dispensed manually or purse. This is generally considered the best way to insert or remove currencies Wallet, allowing the Card Account Control take accurate inventory of coins in the change tubes. To access this feature, enter the service mode and use the arrow keys up or down to get to the menu Insert or dispense coins and then. The screen should now change to show the lowest denomination of coins in the US and Canada this will be.



The development of solutions in the queue management system

The display queue management system should show the deleted error and then display either category following error, or the message No errors. In some cases, errors reported immediately, may reappear after being deletedand the specific number of coins that have the control card for each tube. You can use the Exit key button to exit the see this function Insert or dispense coins. As the coins are dispensed, you should see decrease in the level of inventory of each coin value according to information from the screen. In some cases, such as inventory conditions little change in the tube, the coin inventory from decreasing. In most Wallets hide some coins from the control card.


 

This is done to increase the number of coins in the bottom queue management system of the tubes change to ensure the reliability of delivery, in exchange currencies. Control Board is aware of this and uses a complex algorithm to track inventory of currency exchange tubes. When the control card first enter the service visit here mode or dispense Insert Coins and Banknotes is prevented. When the control card is set to Insert or dispense queue solution software coins mode of acceptance of the currency it is automatically enabled.